A good business alarm system is designed around your building and the people who use it, then installed, tested and explained so that staff arm it without thinking. The panel brand matters less than three decisions: where the detectors go, whether the system is wired, wireless or a mix, and who is told when it trips. We install and service wired and wireless intruder alarms with app control and instant alerts across London, Kent, Essex, Surrey and Sussex, and this guide sets out how we would work through those decisions with a shop, office, workshop or managed property.
TL;DR
- An intruder alarm reacts the moment a sensor trips; CCTV shows you what happened. Most premises benefit from both.
- Choose wired, wireless or a hybrid by the building: wired suits new fit-outs and long-term sites, wireless suits occupied premises and quick installs.
- Decide who gets told: you and your staff by app alert, or a monitoring centre that can call keyholders and, where eligible, request police attendance.
- Police response is withdrawn after three false calls in a rolling 12 months, so design, user training and servicing matter as much as hardware.
- Plan for the 2027 analogue phone switch-off so your alarm signals do not depend on an old landline.
Table of Contents
- What a business alarm system actually consists of
- Intruder alarm or CCTV: which does your business need?
- Wired, wireless or hybrid
- Who gets told: the decision that matters most
- Police response: what the rules require
- Keeping false alarms down
- The 2027 landline switch-off
- What does a business alarm cost?
- What to settle before installation
- How we approach business alarms
- FAQ
- Sources
What a business alarm system actually consists of
The UK's national protective security authority, the NPSA, describes an intrusion detection system as having at least a control panel and detectors. In a typical business installation that means:
- Door and window contacts, which trigger when an opening is moved.
- Movement detectors, usually PIRs (passive infrared sensors that react to body heat moving across a room), sometimes microwave detectors.
- Glass-break sensors and vibration detectors for shopfronts, glazed offices and roller shutters.
- A control panel or keypad that staff use to arm and disarm.
- Sirens and strobes, inside and outside the building.
- A communicator that sends the alarm signal by broadband or mobile network, and to your phone if app alerts are set up.
The NPSA stresses that choosing the correct detector for the environment is of utmost importance. It gives examples: microwave detectors where a PIR would struggle in a bright glass atrium, and beam detectors across large open areas such as warehouses. It also notes that break-glass sensors must be placed where they can be inspected, because their strips and microphones are easy to tamper with. This is why a survey of the premises comes before a quote: the same shop-unit template will not suit a glazed office, a cold store and a yard.
Intruder alarm or CCTV: which does your business need?
They solve different problems. An alarm raises the alert the moment a door contact, movement detector or glass sensor trips, but it cannot tell you who or what set it off. CCTV shows what is happening and records evidence, but a camera nobody is watching does not warn anyone in time.
For a small business the practical answer is usually both, linked by your phone. With app control you get an instant alert, open the camera view, and see in seconds whether it is a burglar, a cleaner with the wrong code or a gust of wind through a shutter. That one look saves an unnecessary night-time drive to the premises and often a false call-out. We fit CCTV with remote smartphone viewing alongside alarms for exactly this reason, and the two can be planned together in a single survey rather than as two separate jobs.

If you also need video door entry for deliveries and visitors, or reliable networking so that cameras and alerts stay online, it is cheaper and tidier to plan them together too. Cameras, app alerts and communicators all depend on a stable network, and we also install business WiFi and networking.
Wired, wireless or hybrid
There is no universally better option. It depends on the building and how long you will be in it.
| Wired | Wireless | Hybrid | |
|---|---|---|---|
| Installation | Cabling through walls and ceilings, more disruption | Fast, little or no disturbance to the building | Wired where cabling is easy, wireless where it is not |
| Best for | New fit-outs, refurbishments, larger long-term sites | Occupied shops and offices, rented units, listed or awkward buildings | Premises with mixed areas or planned expansion |
| Upkeep | Low | Battery and signal strength checked at each service | Both, as relevant |
A wireless system is not a lesser one. Modern wireless detectors are quick to fit and move if you relocate or reconfigure the floor plan. The trade-off to plan for is battery life and radio signal across thick walls, steel racking or large yards, which is where a survey and a proper test after installation earn their keep. For a rented unit where you may move in three years, wireless is often the sensible choice. For a purpose-built site you will occupy for a decade, wired reliability is hard to beat. We install both and will say which fits the building after seeing it.
Who gets told: the decision that matters most
How an alarm is monitored shapes what happens at 3am far more than the hardware does. ProtectUK, the police-backed security advice site, splits systems into two groups:
- Monitored systems send a signal to an alarm receiving centre, a staffed control room that notifies the police or your keyholders.
- Audible-only systems sound a siren to deter an intruder and attract attention. The police will not normally attend an audible-only activation unless other factors suggest it is genuine, such as reported breaking glass.
In practice, small businesses end up with one of these set-ups:
- Bells only. Noise and a strobe. Nobody is told directly.
- App and phone alerts. The system messages you and nominated staff instantly. This is the setting we specialise in: app-controlled alarms with instant alerts to your smartphone, so you can arm, disarm and check the system from anywhere.
- Keyholder monitoring. A monitoring centre receives the signal and phones your keyholders.
- Police response. A tightly regulated route, covered next.
For most small premises, app alerts to two or three people who can act are a strong, affordable starting point, and they combine well with cameras so you can verify before anyone travels. The weakness in any alert-based set-up is the list of people: choose people who will actually answer at night, and keep the list current as staff change.
Police response: what the rules require
Police attendance is not something you can simply buy with any alarm. The NPCC (National Police Chiefs' Council) publishes Police Requirements for Security Systems, updated in 2024. The main points a business owner needs:
- Installation, maintenance and monitoring companies must be certificated by a UKAS-accredited body.
- A system with a police-issued URN (unique reference number) gets Level 1 response, which is immediate but not guaranteed, until false calls build up.
- After two false calls in a rolling 12 months you are advised in writing. After three, response is withdrawn, no sooner than 14 days from the withdrawal letter.
The industry body NSI says the same in plain terms: to get police response, a business needs an approved installer recognised by the police and an approved alarm receiving centre, and systems installed since June 2019 must conform to PD 6662:2017 and BS 8243. ProtectUK also advises that any monitored alarm should have at least two keyholders who know the controls, can grant access, can be reached by phone and can attend within 20 minutes.
A second detection that confirms the first is how modern systems cut false calls. Insurer RSA's commercial risk-control guide says many commercial premises should have a Grade 3 system to EN 50131 and PD 6662, set up as a confirmable alarm to BS 8243, where a second sequential detection confirms the first to the monitoring centre. It also says alarms should be installed and maintained by a company certified by NSI or SSAIB.
The practical advice: before you buy anything, ring your insurer and ask what they require for your premises, trade and stock value. Your policy may specify a grade, a monitoring level or a certified installer, and that requirement, not the sales brochure, defines the system you need. Where the policy asks for police response, say so at the start of the survey so the design and monitoring route are chosen to match.
Keeping false alarms down
False alarms are the main way a business loses police response, and most are avoidable at the design and training stage. Common causes include:
- Staff or cleaners entering the wrong code, or re-entering after the system has been set.
- Doors or windows not fully closed at lock-up.
- Roller shutters rattling in the wind.
- Stock stacked too close to detectors, or heaters and air conditioning blowing across them.
- Flat batteries in wireless devices.
The fixes are mostly routine: train everyone who holds a code, walk the exit route when you close up, keep detectors clear of stock and heat sources, and have the system serviced on schedule so batteries and signal strength are checked before they fail. Give each user their own code so that the event log shows who did what; after any false alarm, read the log and fix the cause the same week. Our alarm servicing and maintenance covers existing systems too, and we set up each installation, test it and show you and your staff how it works, which is where most false alarms are prevented.
The 2027 landline switch-off
If your alarm signals over an old copper phone line, check this now. The UK's analogue phone network is being retired, and the published schedule puts the final switch-off at 31 January 2027, with Openreach reporting in July 2026 that roughly 350,000 business premises had yet to move. Security Journal UK has reported that alarm signalling problems, including broadband outages and over-reliance on mobile signal for both signal paths, have fed a rise in false alarms.
For your business this means asking a simple question: how does my alarm send its signal? A communicator that uses broadband or a mobile network, ideally with a back-up path, keeps working when the landline goes. If your panel is older and tied to a phone line, a survey will show whether it needs a new communicator or replacing outright. Reliable networking behind your alarm and cameras helps here, and we install both.

What does a business alarm cost?
Prices vary too much to quote a single figure fairly. The main drivers are:
- The size and layout of the premises, and the number of detectors and sounders.
- Wired, wireless or hybrid, and how difficult cabling would be.
- The grade of system your insurer asks for.
- Whether you add cameras, door entry or networking.
- The monitoring level, from app alerts to a staffed monitoring centre.
- Ongoing servicing.
We do not publish fixed prices because every property differs. We tailor each system to the property's needs and aim to keep it effective and affordable, with the quote based on a survey rather than a guess. When you compare any quotes, make sure each describes the same thing: same number of detectors, same grade, same signalling, same servicing. A cheap quote that leaves out a detector in the stockroom is not cheaper.
What to settle before installation
A short list saves most of the problems we see in alarm projects:
- Your insurer's requirements. Grade, monitoring and certification.
- A written survey and design. Where each detector and siren goes, and why.
- The signalling route. Broadband, mobile or both, and what happens in an outage.
- Who holds codes and who is a keyholder. Two reachable people at minimum, per ProtectUK's advice.
- Handover and training. Everyone who arms the system should have been shown how, and told what to do when it trips.
- A service plan. Annual servicing or maintenance, so the system stays reliable.
If you are taking over premises with an existing alarm, do not assume it works. Have it surveyed and tested before relying on it. We can inspect and service existing alarms as well as fit new ones.
How we approach business alarms
We are a Sevenoaks-based installer of intruder alarms, CCTV, networking, Starlink, door entry and video doorbells for homes and businesses across London, Kent, Essex, Surrey and Sussex. For a business alarm, we tailor the system to your property, install it, configure and test it, show you how to use it and stay available for support afterwards. Wired and wireless systems both come with app control and instant alerts to your smartphone, so you can monitor the premises from wherever you are.
If you manage a shop, office, unit or a portfolio of properties, get in touch through our website and we will talk through the premises, the insurer's requirements and the right mix of alarm, cameras and networking.

FAQ
Can a small business use a wireless alarm?
Yes. Wireless alarms install quickly without cabling through the building, which suits occupied shops, offices and rented units. They need battery and signal checks at servicing, which is part of keeping any system reliable. We fit both wired and wireless systems with app control.
Will the police respond to my business alarm?
Only if the system meets the police requirements: a certified installer, an approved monitoring centre and a police URN. Audible-only alarms are not normally attended unless other evidence suggests a crime. Response is withdrawn after three false calls in a rolling 12 months, so training and servicing matter.
Is CCTV or an intruder alarm better for a business?
They do different jobs. The alarm alerts you immediately; CCTV shows you what is happening and records evidence. Together, with app alerts and live camera viewing on your phone, you can check an alert in seconds before deciding what to do.
How many keyholders do I need?
ProtectUK advises at least two keyholders who know the controls, can give access, can be reached by phone and can attend within 20 minutes. Keep the list current as staff change.
Sources
- NPSA: Intrusion detection
- ProtectUK: Alarms and CCTV
- NPCC Police Requirements for Security Systems 2024
- NSI: Intruder alarm systems for business and commercial premises
- RSA: Security risk control guide
- Security Journal UK: Why false alarms from intruder systems are resurging
- PSTN switch-off January 2027: UK business checklist
